[Jewelry making - Article 00122] - Re: [Orchid] Gas PSI's for Swiss Torch

[SERVE4GWM]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Many gas torches, perhaps from familiarity, fear of possible
    liability, or simply lacking good customer support, fail to have
    adequate installation and operating instructions. As a general rule,
    for oxygen/gas systems, the oxygen regulator should be set at
    appoximately twice the pressure of the gas regulator. This will give
    you a proper mix of gas for ignition, which can then be adjusted at
    the torch handpiece to produce a Reducing, Neutral, or Oxidizing
    flame. 

Best Regards,
Gary W. Miller, Sr. Technical Advisor
Spirig (www.spirig.org)
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________