[Jewelry making - Article 00930] - Re: [Orchid] Hammer Textured Rolling Mill?

[Noel Yovovich]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     So I found out the hard way that if you hammer (peining again)
>     depressions into a steel plate that are deeper than the thickness
>     of the metal you plan to roll through the mill with said plate... 

    I'm sure I'm not the only one who reads the progress of this project
    with interest, sympathy, recognition (sounds like problems I've had)
    and relief (not my problem this time!) 

    When you've beaten this project into submission, I encourage you to
    consider offering these plates to the jeweling community (us)-- I'm
    sure there's a market for them. You might even end up making some
    return on your investment of time, determination and ingenuity. 

Noel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________