[Jewelry making - Article 01204] - Re: [Orchid] Retipping using laser welder

[Scott Isaacs]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Continue from:
http://www.ganoksin.com/orchid/archive/200409/msg00320.htm


    I think I found the best setting for retipping. I used 210v 4ms 12
    beam focus. I think this setting is perfect for building up prongs. I
    know Rofin says that 230v is good, but I have found that to be too
    high. It leaves the prong blue on top and from what I have heard that
    means the setting is too high. 

Scott
Berrry's Jewelry
Nashville,TN

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________