 |
These tweezers are great for gripping melee when you slide then into position in continuous channel setting jobs. Here you see the very fine tips on these tweezers. |
 |
Measure down the tips until they are 0.5 mm wide and make a mark. |
 |
Please wear your safety glasses for all the grinding on this project.
use a separating disc to cut the tips off evenly where they are marked. |
 |
Use your separating disc to grind a 45 degree angle on both tips. |
 |
Use a diamond wheel to dress the edge of your separating discs until it comes to a sharp edge. Make sure the sharp edge is even on both sides. |
 |
With your sharpened disc score a groove about 0.25 to 0.5 mm from each end. |
 |
Try to hold a melee and if necessary make your grooves on the tips deeper until you can hold melee securely. |
 |
Close up of the tips with the grooves cut in them. These tweezers make it a lot easier to handle melee with out them flying. |
