[Jewelry making - Article 00498] - Re: [Orchid] [Mokume-Gane] Seamless Join Band Ring

[David D. Arens]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Could it be that the ring was made from a pice of mokume that
    was as thick as the ring was wide?  The hole for the finger would
    then be drilled/bored & the outside diameter, sawed or turned. 

    That's one way to make a ring as you described. I don't have a
    clue how you could size it without leaving some identifying
    marks. 

Dave 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________