[Jewelry making - Article 00817] - Re: [Orchid] Steam Casting for Pewter

[WINIPOO]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    When I was in school, working in pewter was looked down upon.
    Apparently, pewter can contaminate your work surface, or
    something like that? It was recommended that, if you were to work
    in pewter, you set up a separate work station for this. I do not
    know any details, and I could perhaps just be remembering this
    all wrong. Can anyone supply me with the deeper knowledge ;-)
    Regards, Kirsten in PA 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________