[Jewelry making - Article 01055] - Re: [Orchid] Using Split LapPolisher

[Alberic]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Gerry:

    The light needs to be directly above the wheel (so as to shine down
    through the splits). It's best if it's a florescent light, as the
    strobing of the light should synch up with the spinning of the wheel,
    and give you a pretty clear view in certain spots. (I've used mine in
    daylight, so the strobing isn't required, but it sure is nice when it
    works out.) 

FWIW,
Brian Meek.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________