[Jewelry making - Article 01044] - Re: [Orchid] Using Split LapPolisher

[Gerald Koshman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Good morning,

    One more dumb question and I promise I'll leave this subject alone.
    I just rec'd my lap and I think I'm doing something wrong as I can't
    see all that well thru it. When I'm using it I can barely see an
    outline of the piece I'm working on. 

    Any suggestions, different light maybe or different light position? 

Thanks
Gerry
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________