[Jewelry making - Article 01040] - Re: [Orchid] Decent jump ring cutter?

[LainieD]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Rick and All

    I junked the sawblade for my jumpringer pretty quickly and now use a
    diamond disc in my Foredom and cut freehand. It makes a much smaller
    slice. On occasion, before actually sawing the jumps, I use a
    heatless mizzy to grind off part of the jump ring (usually at the
    cut) thus getting more of a contact if I solder the ring to
    something. 

Lainie
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________