The Gem and Jewelry World's foremost Resource on The Internet.
Re: [Orchid] [Source] Indexed ring mandrel  
  [Thread Prev] [Message Prev]      [Date Index]   [Thread Index]      [Message Next] [Thread Next]
From: leonid surpin
Date: Mon May 19 19:57:37 2008
 
     
========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I do not have a good source for the indexed ring mandrel, but I can
    offer a substitute which I have been using for many years and it
    will cost you nothing. 

    Take a brass plate and cut out a disk of the diameter a bit larger
    than the largest ring size you think you might need. With the
    dividers inscribe progressively small circles graduating towards the
    center. On mine each circle corresponds to ring size. Divide the
    circles as required for application. 

    To achieve precision in dividing circles, use intersecting arcs
    method. Start by drawing diameter ( any line through the center. Next
    position one point of dividers on the intersection of diameter and
    the circle, open dividers more than 1/2 of the diameter and draw an
    arc which would cross the area where the center would be. ( no great
    precision required ). Position dividers on another intersection of
    the diameter with the circle and draw another arc in the same manner.
    The arcs will intersect exactly opposite the center of the circle.
    Using intersection of arcs and the center of the circle draw a line
    until it intersects the circle on another side. You have divided
    circle into 4 equal arcs. 

    Using the same method you subdivide each arc into required number of
    subdivisions. Use sharp scriber and when done, mix some artist oil
    paint with turpentine and rub into the marked lines. After it dries,
    use emery stick to remove excess of paint and the scribed lines will
    stand out sharply against the metal. Now you have a permanent
    circular ruler which you can use to divide rings into any number of
    divisions. 

Leonid Surpin
www.studioarete.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________

  Click to Visit  
     
  Navigate:  
   
  Orchid Resources:  
   Join & Post
 Invite a friend to join Orchid
 F.A.Q
 Galleries
 BenchExchange
 Orchid Message Archives [Subject Index] [Date Index]

Ganoksin now offers a number of ways for you to stay on top of the latest from Orchid!

  1. My Yahoo - Do you have a My Yahoo page? If so, you can easily read the latest Orchid posts on your personalized page by adding this feed:Add Orchid to My Yahoo!
  2. Add Orchid to myGoogle Add to my Google
  3. Read Orchid with NewsGator and Microsoft Outlook Add Orchid to Your  NewsGator
Support Orchid! - If you believe in what we're doing, you can help!

 
     
     

© Copyright 1996 - 2008, The Ganoksin Project