[Jewelry making - Article 00559] - Re: [Orchid] Resin pulling away from the bezel walls

[BeadStorm]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have used these products for many years without that problem, but I
    wonder if you might be able to avoid this by heat curing your items
    in a small portable toaster oven. I have mine set to 150 degrees F
    and cook my items for 2 hours or so to set the resin. Otherwise, I
    would contact the manufacturers of the Durenamel for advice or a
    different hardener. 

BBR - Sandi Graves
Stormcloud Trading Co (Beadstorm)
Saint Paul, Minnesota
651-645-0343
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________