[Jewelry making - Article 00504] - Re: [Orchid] First wholesale show

[Janet Kofoed]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Find a way to raise your table to counter height 

    I did this recently, to the Sam's club folding tables. I measured
    the diameter of the table legs and went to Home Depot, finding PVC
    pipe of the same diameter, and also straight connector fittings that
    fit the PVC pipe. I now have PVC risers, with the fittings on one
    end, that just slip over the legs when I'm setting it up. I had to
    wrap a turn of duct tape around the legs for them to fit snugly. 

    I lifted them about 7 inches, to the same height as the narrow 4
    foot Sam's club table at its highest adjustment. It seems to be a
    good height; not so much back strain among the customers, and less
    accessible to little hands. 

Janet Kofoed
http://users.rcn.com/kkofoed
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________