[Jewelry making - Article 00478] - Re: [Orchid] Flexshaft vibrating in the shaft itself

[Helen Hill]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     A dremel vibrates *much* more than a Foredom should. Why screw
>     around asking us? Get in touch with your seller or with Foredom. 

    In my case, as I said it was due to the fact that I was not used to
    the extra torque and it was a possibility that the same was the case
    with the person who asked the question - but apparently not. 

    I only had a problem with it for a few minutes initially until I got
    used to the foot control, and ever since then it has been as smooth
    as silk. 

Helen
UK
http://www.hillsgems.co.uk
http://www.helensgems.etsy.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________