[Jewelry making - Article 00452] - Re: [Orchid] Flexshaft vibrating in the shaft itself

[Noel Yovovich]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     I recently upgraded from a Dremel to a Foredom too. I had the same
>     problem at first but soon realised that it was due to the extra
>     torque of the Foredom and the fact that I wasn't used to it. 

    This is not correct. A dremel vibrates *much* more than a Foredom
    should. Why screw around asking us? Get in touch with your seller or
    with Foredom. 

Noel
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________