[Jewelry making - Article 00346] - Re: [Orchid] Cleverwerx soldering set

[Karen Christians]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Helen,

    This is a problem I have had with all picks. The stock is so thin
    that it won't stand up to any pressure. You want to have one pick in
    one hand to transfer solder and then apply pressure if needed. The
    one for Cleverwerx will do just that. Same with the crosslocks, they
    will stand up to pressure, they will never distort. 

    You won't need any insulating material because titanium is a poor
    conductor of heat. Its flat construction and then the twist at the
    end, allows you to lift the pick up quickly from a flat surface. It
    won't roll either. 

    Thanks for asking. Your questions are all good ones and it makes me
    stay on my toes to make a good product. 

Best,

Karen Christians
Cleverwerx
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________