[Jewelry making - Article 00260] - Re: [Orchid] Scratches on Rolling Mill

[Richard Whitehouse]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Kim,

    The rollers on your roller are made from very hard steel. The best
    solution is to take it to a machine shop that can skim the surface of
    the roller to remove the scratch. 

    If you try to do it by hand it may create an uneven surface. 

Richard UK
www.richard-whitehouse.co.uk
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________