[Jewelry making - Article 00242] - [Orchid] Scratches on Rolling Mill

[myjung kim]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello,

    Just wondering if anyone has a solution. I scratched a roller on my
    rolling mill, not too much that it affects the result of rolling a
    piece of silver, but shows on the surface of the roller. Is there
    any way of getting ridof the scratches? They are not very deep, it
    looks like it was made by a piece of extra fine sandpaper. 

Thank you!
M. Kim

 
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________