[Jewelry making - Article 00060] - Re: [Orchid] Searching for a rolling mill

[Mlou Brubaker]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     I think that a mill that can accommodate a max. of 14 gauge sheet
>     and wire is what I want.. 

    Barbara, remember to allow for running some sheets of copper or
    brass through the mill with your metal, if you might use materials
    like metal screen which would mar the rollers without protection. 

M'lou
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________