[Jewelry making - Article 01037] - Re: [Orchid] Laser Wire Feeding Tool?

[Alberic]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Neil:

    I just drew down some thin brass tube so that it was pretty tiny (yet
    with thick walls) and used that. It wasn't a totally tight fit on the
    wire, more of a guide pipe. I had a little piece of wire crossways
    (and below) off the back that I could spike the hub of the reel on.
    (Originally, the wire I was using didn't come on reels, so I used
    those little plastic ones that microchip people use for bonder wire.)
    Not a horribly helpful description of the reels, but it's what I
    have. (I have odd friends.) 

HTH
Brian Meek.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________