[Jewelry making - Article 01007] - Re: [Orchid] Laser Wire Feeding Tool?

[Rona]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    this really simple method works great for us: Take a chopstick ( or
    any other small dowl)- cut it about 1"- 1 1/2 " long. Drill a hole in
    one end. poke your laser wire through it and bend. wrap your wire
    around your newly created mini-mandrel allowing maybe 5mm or so to
    stick out for welding. mark the end so you know what's on there- ss,
    14ky, etc. we've found it very useful to have some.35 wire on hand as
    well for fill in welds or areas that need to be built up just a bit. 

happy welding!
Rona
ronafisher.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________