[Jewelry making - Article 00101] - Re: [Orchid] Rubberized abrasive cones discontinued

[Brett Gober]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    It sounds like Rio did you a favor. 60 - 90 seconds is way too slow
    with a normal as-cast surface. I use the 60 micron 3M micro-abrasive
    film cut into strips and wound on a wood straight split mandrel. 

Brett
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________