[Jewelry making - Article 00006] - Re: [Orchid] High speed spindle

[David J McIntyre]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    For those who are interested in the Harbor Freight Micro Die Grinder
    that Hans Stengier mentioned, I will remind you of my offer of one
    year ago. Any of you who will make a contribution to Orchid, send me
    your address and I will send you a pair of brass bushings which allow
    you to use 1/16 and 3/32 inch burs in the 1/8 inch collet that comes
    from Harbor Freight. NO CHARGE, JUST CONTRIBUTE AS MUCH AS YOU WISH.

Dr. Mac
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________