[Jewelry making - Article 01226] - Re: [Orchid] Appropriate gauge for flush setting

[Jessica Frenkel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Dear Mr. Surpin,

>     To draw connection between stone diameter and metal thickness is
>     raising the question of how we approach the setting of 10 mm stone.
>     It should be obvious that depth of the stone should be compensated
>     by other means then increasing metal thickness. 

    I do not disagree with your point. I do wonder however, if you could
    elaborate on your point number three. Thank you in advance. 

Sincerely,
Jessi
p.s. I hope you had a nice trip.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________