[Jewelry making - Article 01126] - Re: [Orchid] High speed spindle

[Jeff Demand]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have a Proxxon IB/E for a spindle on my Taig mill. It works very
    well for wax and doesn't make much noise. I also have a dental sized
    air hand piece, very high speed (50K + ??) It makes the most
    annoying high pitch whine which is not masked by the racket of the
    compressor. And the compressor is in an attached insulated dog house.
    Air tools also really suck air, check out the air consumption (double
    this optimistic sales number) and needed pressure. Approach air tools
    with caution, OK for brief jobs but not 10 hour overnight runs. 

Jeff
Demand Designs
Analog/Digital Modelling & Goldsmithing
http://www.gmavt.net/~jdemand
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________