[Jewelry making - Article 00998] - [Orchid] Bench dimensions

[Terry paulsen]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Have the need to build a proper work bench, I do silver smithing and
    am starting to do wax carving. 

    does anyone have suggested dimensions for a jewelers bench, hieght
    from floor to top, how deep should it be made, how far the catch
    tray should be below the bottop of the bench top, the radius of the
    cut out, and the location and height of the arm rests. 

    Thanks in advance for your advice and assistance. 

O M
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________