[Jewelry making - Article 00869] - Re: [Orchid] Freehand engraving using flat engraving machine

[Neilthejeweler]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Yes, can be theoretically done. But tough. I've done it. Its like
    drawing with a mouse. To make it easier...transfer the letter to a
    plate of brass or something that clamps in the machine. Cut deep
    guide lines accordingly. 'Tain't easy to have out come out well. If
    this is going to be used on a repeated basis you might have an
    engraving shop with a computer layout make a master for you. 

    My first position in this biz was as a machine engraver. After a
    week of learning I had nightmares of me, running in the grooves of
    the letterplates, with the stylus hot on my heels. Glad those days
    are over.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________