[Jewelry making - Article 00860] - Re: [Orchid] Freehand engraving using flat engraving machine

[james newton]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Over the years I have used the pantograph charactor of several Hermes
    engraving machines to "trace" drawings, signatures, logos, etc, very
    effectively. You certainly won't have the brass type to hold your
    stylus on course, but with a steady hand you can do this quite
    easily.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________