[Jewelry making - Article 00840] - [Orchid] Which roller mill for me?

[Toni]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi

    I know this is a recurring question on ganoksin and I have been
    through the earlier posts but don't seem to be able to find an
    answer for me. 

    I find that at last I am in a position to buy a rolling mill and a
    fairly good one. 

    My understanding from previous posts is that Durston are pretty much
    the best of the best so at this stage that's what I'm looking at. 

    I make small jewellery items and want the mill to reduce sheet and
    wire guage, to make square and half round wire and to transfer
    designs to sterling sheet. This I believe means I need a combination
    rolling mill. 

    Now is it better to pay to get a machine with gear reduction or
    extra width. I know I will have to compromise somewhere but where is
    the question. 

Thanks
Toni
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________