[Jewelry making - Article 00820] - Re: [Orchid] Hydraulic press problems

[Sam Patania]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    You could look for a press owning Orchid member in the area you live
    in and ask if they could help you figure oout what is going on.
    Designing for the press is different than other fabrication
    processes and you need to know the differences. Instead of pissing
    money away on bad tools, get the advice first, you may find good
    tools cost less in the long run. Also go to the Bonny Doon forum and
    ask questions before you spend another dime, I can be contacted off
    list for specific questions and so can many other Orchids and BD
    forum members. 

Sam Patania, Tucson
www.silverhuntress.com
www.bahti.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________