[Jewelry making - Article 00172] - Re: [Orchid] Favorite Tubing Cutter?

[Gary]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I think what you need is little device that used to be called a
    Jointing Tool, but is also known as a Chenier or Tube Cutter. 

    The one I use is pictured here... 

    http://tinyurl.com/36bq36 shows the tool ready for inserting a piece
    to be cut - the little lever is holding the item as shown in... 

    http://tinyurl.com/yuvt9j which shows a piece of tube being cut with
    a piercing saw. 

    I've had mine for about 25 years and wouldn't be without it. 

    The following link shows a similar one available here in UK...
    http://tinyurl.com/ywux7h 

Regards, Gary Wooding
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________