[Jewelry making - Article 00903] - Re: [Orchid] Rolling mill stand on concrete

[Rick]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     a stand with a dolly underneath it that has locking wheels is a
>     great solution as it allows the user to move it where needed and
>     replace out of the way when not in use. 

    What a good solution. I got my rolling mill used and it is mounted
    to a handmade stand with a large truck rim as a base. When I use the
    rolling mill I end up dancing with it across my shop. If I can make a
    base with wheels that I can stand on I'll have the best of both
    worlds. 

Rick Copeland
Silversmith and Lapidary Artisan
Rocky Mountain Wonders
Colorado Springs, Colorado
rockymountainwonders.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________