[Jewelry making - Article 00858] - Re: [Orchid] Rolling mill stand on concrete

[Brian Symons]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    There are achors called Chem Sets or something similar. You drill
    your hole in the concrete put in the glass capsule of chemical &
    insert your anchor bolt item which is chucked in a drill. 

    When you put the bolt section in you smash the capsule & the turning
    the drill on cases the chemical to mix. It then sets. It will never
    come out. 

    Call any large bolt supplier or building supplier & ask them. 

Regards,
Brian.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________