[Jewelry making - Article 00847] - Re: [Orchid] Rolling mill stand on concrete

[Jim Reitze]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    In a shop where I used to work, the stand had been welded to a large
    and heavy steel plate. This was not a perfect solution, but it was
    fairly workable. Enough pressure on a stubborn roll would shift it
    around a bit, but there was never a risk of it coming loose and
    tipping over. An additional advantage was the ability to move it
    around if needed, though it took some muscle to do so. 

Jim
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________