[Jewelry making - Article 00834] - Re: [Orchid] Rolling mill stand on concrete

[LainieD]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Mark,

    My sweet hubby used 3/8ths by 5 inch self tapping tapcons to anchor
    my rolling mill into my concrete floor. After two years of (ab)use
    it is still firmly anchored. Best of luck to you in not hitting a
    piece of rebar or spinning the head of the tapcon as you drill! 

Lainie
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________