[Jewelry making - Article 00698] - Re: [Orchid] Otto Frei's Economy Rolling Mill

[Rick]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     $45 Lindstroms 

    I try to buy good used tools but have bought my share of cheap
    imports and have replaced them with quality when they didn't do the
    job I needed them for. One thing I go for the high dollar tool for is
    flush cutters. I use flush cutters to cut silve bezels and that's
    pretty much it. So I too buy the $40 Lindstroms when the quaility is
    required to do the job. 

Rick Copeland
Silversmith and Lapidary Artisan
Rocky Mountain Wonders
Colorado Springs, Colorado
rockymountainwonders.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________