[Jewelry making - Article 00653] - Re: [Orchid] Proper height for a jewelers bench

[Karen Strauss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thank you David, Akiko and Juliette for your fast responses to my
    dilemma! I am rather tall (5' 10'') so many of your suggestions could
    work. 

    I'm concerned about removing the bottom drawer, because it is
    resting on wood that is permanently attached to the bench, so removal
    might weaken the entire structure. I would love to see the photos of
    Akiko's bench. And, is a bench skin a piece of fabric that can be
    attached ? 

    Also........... There are 2 slats just under the bench top that have
    long pieces of wood which can be pulled out or pushed in flush with
    the bench. Is that for adding an additional work surface? 

So many questions!
Merci encore,
Karen
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________