[Jewelry making - Article 00648] - Re: [Orchid] Epoxy question

[Mlou Brubaker]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    You could flatten the end of the wire to the diameter of the hole,
    then twist it to make a wire that will hold glue better. Just use a
    pin or wire to put the epoxy into the hole, plunging it up and down
    until the hole is full. Then put your twisted wire in, and wipe off
    the excess glue. HTH! 

M'lou Brubaker, Jeweler
www.craftswomen.com
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________