[Jewelry making - Article 00610] - Re: [Orchid] Hatch latch

[Ian W. Wright]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Bobi,

>     I'd like something more like a roulette wheel with a center pivot
>     that stays stationary and has an ultra smooth, class act of a
>     spin. - I know there is a simple, elegant solution. I just haven't
>     found my way there yet. Any advice appreciated. 

    D'you know, I'm very much inclined to suggest the same kind of
    magnets but this time use their repulsive force to 'float' the
    table!!! Maybe a ring of the little magnets set at 45 degrees around
    the base of the centre spindle with a corresponding set on the
    underside of the table......

Best wishes,
Ian
Ian W. Wright
Sheffield UK
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________