[Jewelry making - Article 00571] - [Orchid] Proper height for a jewelers bench

[Karen Strauss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

I have a question about the proper height for a jewelers bench.

    I recently purchased a beautiful, wooden, full-size bench from an
    estate sale. It came with an adjustable chair, but while sitting at
    the chair's lowest level, my knees bang into the bottom (permanent)
    drawer of the bench. My husband suggested raising the entire bench
    onto wooden blocks, but then the bench top would be too high to work
    on comfortably. 

    Hopefully, someone will have a suggestion so I can use this
    wonderful addition to my studio. 

Thanks,
Karen Strauss
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________