[Jewelry making - Article 00565] - Re: [Orchid] Rolling mills square wire grooves

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Brain

    These are cut on Turning Lathes. The Tool bit is not narrow and
    pointed you cannot be changing the tool bits so often either. 

    Even if one makes a 90' on a roller and say with a stroke of luck
    matches the top and bottom what happens to the other two corners of
    the wire that are now between the rollers. 

    Rolling mills are not for perfect square or round wires. You have to
    use draw plates. 

Kenneth Singh
46 Jewelry Supply
Karat Rolling Mills
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________