[Jewelry making - Article 00235] - Re: [Orchid] Trying gem carving

[Rose Alene McArthur]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    In my opinion, you would be much better in the long run going with
    the sintered carving tools. The ones with the diamond coating are not
    going to work once the outer coating is ground away. The sintered
    ones have diamond incorporated throughout the whole grinding body. 

Rose ALene
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________