[Jewelry making - Article 00192] - Re: [Orchid] Building servo driver

[Terry Ogden]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Ian

    The 35v zeiner should work, at 35 it is still in spec for the
    2SC2712 and there is limited opportunity for an over current. 

    Yes, the input range for the 7805 is 35VDC, but it is really limited
    as to how much current is available at that voltage differential. 

    Good luck on your project, if you need help or want to discuss, drop
    me a line. 

Terry
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________