[Jewelry making - Article 00168] - Re: [Orchid] Scratches in Stainless Steel

[Neilthejeweler]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Is there a way to buff the scratch(es) out? There is one that is
>     across the front (side to side, against grain), she said they are
>     not very deep though. 

    Sounds like it has a satin finish. You'd need to find an abrasive
    that matches the effect of whatever was originally used. Could be
    sandpaper, wire brush, pumice or some other grit. And you'd have to
    duplicate the polishing pattern. 

    However if you try this you may wind up refinishing the entire door.
    That's a large area to do by hand and have it come out even. Be
    cautious in case there has been a clear coat of some sort applied. 

    My own feeling is to pass on the repair if possible. can of worms,
    marriage job with no divorce in sight.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________