[Jewelry making - Article 00090] - Re: [Orchid] Building servo driver

[James Binnion]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     The circuit shows the motor supply of +6 - 15v (I would actually
>     like to use 24v and am using higher voltage FETs) connected directly
>     to the output of the 7805 regulator and the motor 0v connected to
>     ground. 

    Look again, the 6-15 V supply is connected to the input pin of the
    7805 not the output pin. Also if you use 24V as a supply you will
    want to make sure you have the 7805 well heat sinked as it will
    dissipate more of its power as heat at higher input voltages. 

James Binnion
jbin AT mokume-gane.com
James Binnion Metal Arts
http://www.mokume-gane.com
360-756-6550
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________