[Jewelry making - Article 01483] - [Orchid] [Source] Welding cast bronze

[JONLEE]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I need two halves (front and back) of a 3 inch cast bronze medallion
    welded together around the edge (like on the edge of a coin). This is
    a commission for two (2) medallions being presented to two senior US
    Senators in Was hington DC on February 20 (but 3 weeks away). 

    The spot welds must be raised above the edge surface so that I can
    grind the edge surface flat, which I suspect means using fill rod.
    Just about species of metal fill rod that can be finished with
    gold-plating is OK (but NOT brass please). 

    A laser welder, a Puk II or III welder, or similar, or even a small
    TIG welder using a micro-torch might do the trick. 

    Anybody near me in the Bay Area of California willing to take this
    on? 

    Recommendations welcome. 

    Price, when, where, must be soon? 

Jon
Oakland, CA
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________