[Jewelry making - Article 01362] - [Orchid] Large blade with Pepe jump ring maker

[Cher]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi, I am using the Pepe Jump Ring maker and for the first time today
    wanted to cut some heavier gauge jump rings. I put the large blade
    on but it seems to hit the ends of the slot in the top plate. I'm
    wondering if anybody else has noticed this and might have some advice
    for me? I'd appreciate any help. 

Thanks!
Cher
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________