[Jewelry making - Article 00650] - Re: [Orchid] Drilling investigated

[leonid surpin]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     am a watchmaker and would tend to disagree with both of these
>     statements. Certainly multi-fluted reamers are industrial and
>     expensive but a perfectly usable and practical 'D' bit reamer can
>     be made in a few minutes which will open up holes very quickly. 

    I am not sure that we disagree on anything, except perhaps on the
    best way to enlarge a hole. Given our different fields of endeavor,
    it is hardly a surprise. 

Leonid Surpin.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________