[Jewelry making - Article 00509] - Re: [Orchid] Drilling investigated

[Thomas Janstrom]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I have reamers from 0.5mm through to 1" and I have used them all,
    although not all on precious metals. I have even made quite a few of
    them for one off jobs. 

    I didn't mention them because the question really was "just" about
    drilling and was quite general in nature, so I chose not to cloud the
    issue with terms and information that may have been outside the
    experience level of the inquirer. I (rightly to my mind) feel that
    this information should be left to a follow up email (which you have
    kindly supplied) so that the information is supplied in a logical
    progression. 

    I thank you for supplying the next lesson. 

Cheers, Thomas.
Janstrom Designs.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________