[Jewelry making - Article 00318] - Re: [Orchid] Creating a cone

[Bericho]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>     Could you explain this further for me. Seems to me that the length
>     of the cone is the same as the height. I'm mathematically
>     challenged 

    Don't know if this will clear it up - but envision the cone split up
    one side and flattened out. Now you have a cone with NO Height! But,
    from the center to the outer edge is the length of the "side" of the
    cone. And that becomes the radius of the disc. Hopefully this will
    clear up the difference between the height and the side of the cone. 

K
Thank you!
Debbie Parent
Apparently Art
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________