[Jewelry making - Article 00313] - Re: [Orchid] Precision scroll saw

[Steve . Mashburn]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Micromark's miniature scroll saw would probably be great if you were
    a (plastic) model builder, doll house builder, or just cutting balsa
    wood. IMHO, there are too many issues to use it on silver/gold.
    Broken blades (short) will not fit. There is no "clutch" to deal with
    a stuck blade; either your piece of silver will flail up and down
    till you get the thing turned off or the blade will break. 

    I tried cutting silver with it; Let's just say that i was lucky
    enough to sell it and get my money back.
____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________